|
|
|
Victory Air Intake System Removal
Instructions
|
|
Removal of plastic stock cleaner system, use owners
manual if needed.
|
| 1. Remove side covers from bike (side covers pop on and off). |
| 2. Remove seat by unscrewing (2) mounting bolts 6 mm allen head. |
 |
| 3. Remove gas tank rubber mounting bolt covers front right and left. |
 |
| 4. Remove gas tank mounting bolts (2) front and (1) rear 8 mm allen head. |
 |
 |
| 5. Lift rear of gas tank slightly disconnect electrical connector and disconnect vent hose. |
 |
| 6. Loosen fuel line hose clamp and disconnect main fuel line, remove gas tank. |
 |
| 7. Disconnect and remove air temperature sensor. |
| 8. Remove map sensor disconnect wires. |
| 9. Remove air box cover (5) screws, lift out intake tubes. |
 |
| 10. Remove air filter cover and filter. |
| 11. Disconnect crank case breather hose from air box. |
| 12. Using a sharp gasket scraper or chisel and a small hammer split and separate stock plastic air box at it's seam. Remove top portion of plastic air box. |
 |
 |
 |
| 13. Unscrew (4) mounting screws that hold air box to throttle body. Remove
bottom portion of plastic air box, save rubber gasket between plastic box
and throttle body. You will be reusing this rubber gasket. |
| Printer Friendly Instructions |